4" IC Air-Tight Line Voltage Double Wall New Construction Housing
IC Recessed housings are high quality, light weight units ideal for use in insulated ceilings. Air-tight construction reduces energy costs by reducing the amount of air escaping through the ceiling. Rated for direct contact with insulation (except spay foam insulation) and combustive materials, IC housings are easy and quick to install and accept a wide variety of high quality, attractive finishing trims.
IC Air-Tight energy saving by reducing the flow of air through the ceiling
Rated for direct contact with insulation
cULus listed for damp location and through branch circuit wiring
Quick connect provided
24-1/2" Bar hangers with captive nails and alignment foot
Accommodates 1-3/8" maximum ceiling thickness
Dimensions
Length (In.)
8-1/2"
Width (In.)
5-1/4"
Height (In.)
6"
Ceiling Cutout (In.)
4-3/8"
Light Source
Line Voltage
Aperture Size
4"
Construction Type
New Construction, Air-Tight IC
Minimum Clearances:“IC” Housings are direct contact rated; no minimum clearance is required
Socket Plate:Socket plate adjusts inside housing and can be removed in the field to convert to a floating socket
Bar Hangers:Bar hangers are adjustable from 13-5/8″ to 24-1/2″ and can be repositioned 90 degrees. Bar hangers are slotted for T-bar installation and include captive nails.
Maximum Wattage:50W (can be labeled for lower wattages)
0.040 steel frame with integral bar hanger brackets
Housing
0.035 white baked enamel one-piece drawn steel. Accommodates ceiling thickness from 5/8" to 1-3/8"
Minimum Clearance
IC rated for direct contact with thermal insulation. Not to be used in direct contact with spray foam insulation
Air Flow Restriction
Housing has factory installed gaskets to restrict airflow from room into ceiling plenum to <2CFM (cubic feet per minute) in accordance with ASTM-283 AirTight requirements
Socket
Galvanized steel socket plate adjusts inside housing for optimum light performance. Contains a single medium base socket. Protective cap included to protect socket interior during ceiling painting. Socket plate can be removed in the field to convert to a floating socket
Additional Info
Bar Hangers
Two 13-3/4" to 24-1/2" adjustable bar hangers with captive nails are included on frame. Hanger bars have T-Bar slot and alignment feet. Bar hangers are parallel to junction box, but can be repositioned 90º perpendicular to junction box if desired. “L” Shaped bar hanger foot to align to bottom of construction joist. A T-Bar notch allows easy installation in a suspended ceiling
Junction Box
Prewired 25 cubic inch 0.060" thick galvanized steel, with seven 1/2" knockouts, four Romex® pryouts, and snap on covers. All leads are #18AWG wire, the ground wire is connected to the bottom, and quick connectors are supplied on all leads. Through branch circuit wiring, (4-in, 4-out)
Quick Connect Feature
Housing contains three UL approved quick connections that allow insertion of 1/4" stripped solid or tinned standard conductors to be inserted into the connector. Connectors are pre-attached to fixture power, common, and ground circuits
Thermal Protector
Standard UL thermal protector rated for 90°C is affixed to inner top surface of housing
Electrical
Input Voltage
120V
Socket
Medium base
Lamp
R/PAR20
Wattage
50W max (available in wattage reduced 12W or 20W max.)
